RC Lander 90mm 1620kv 6S Metal 12 Blade Dynamic Power EDF

RC Lander 90mm 1620kv 6S Metal 12 Blade Dynamic Power EDF
Click To Enlarge
  • Item #: RCL-LEDFADPS12B90-1A16/6S
  • Manufacturer: RC Lander
  • Manufacturer's Product Number: RCL-LEDFADPS12B90-1A16/6S
  • Condition: New
  * Marked fields are required.
Qty*
Price $229.99
Sale Price $199.99
Availability In-Stock

The RC Lander Dynamic Power Series 6S 12 Metal Blade EDF offers great durability with a full metal fan unit that offers good performance.

All RC Lander fans and motors are test run at the factory to ensure that they are in proper operating manner before being shipped out. The fans are put through a series of tests to ensure that they are operating as intended. Be sure to reference the instruction manual for proper motor and esc program settings.

FEATURES:

A lot of EDF units are made of plastic material which during operation creates high temperature. This results in loss of power and the possibiltiy of damage to the motor, battery or speed control. Heat sinks help, but this only offers average improvement. RC Lander Technology uses special metals to imporve dissapation of heat in their EDF units. The shroud, spinner and tail pipe are made with a special aluminum alloy that is efficient at heat dissapation. Because of this, the whole shroud acts as a heat sink, removing heat from the motor. The motor and fan unit comes assembled and balanced from the factory. A thermal grease compound is used between the motor and shroud to further help dissipate heat. This is the same compound that is used in computer processors and heat sinks. This design creates a more efficiently running motor and will provide peak performance while extending the lifespan of the motor.

BUILDERS NOTE: REFER TO THE "ELECTRIC SETUP GUIDELINE" ON THE HOME PAGE TO HELP DETERMINE THE PROPER SET UP FOR FAN, ESC, MOTOR AND BATTERY.

 

SPECIFICATIONS:  
 Material:  Aluminum Alloy
 Weight:  1.47lb/ 670g
 Rotor:  90mm, 12 bladed aluminum
 Outer Diameter:  94mm
 Max RPM:  42,000
 Power (10 Sec Burst):  2,350 Watts
 Power:  2,200 Watts
 KV Rating:  1,620kv
 Current:  98 Amps
 Battery:  6s/ 22.2V Lipo w/ 40C or higher
 Thrust (Estimated):*  Up to 3.8kg/ 8.3 lb.
 Start:  Soft
 Timing:  High
 Speed Control:  100amp or higher
 Motor:  4 Pole Inrunner

 *(Estimated dependant upon lipo battery quality, air ducting, esc etc..)

Picture notice: The kv of the motor is 1620kv.  RC Lander does not make a 1700kv edf unit.  That is an error on RC Lander's part to have that stated in the picture.

WARNING:Operating the motor outside of the specifications listed above can either damage the motor, battery or esc. It is important that these components are set up properly. Failure to do so can void the warranty. It is strongly encouraged to use a Watt Meter to test the watt and amp performance when setting up a new system. If the output is above the factory recommended specs, then it needs to be adjusted by the esc. The timing and throttle settings on the esc can help to set the appropriate levels.

Related Items