This is an awesome High Quality Composite EDF Jet capable of speeds over 100 mph! Kit comes with fixed gear but we offer an optional Air Retract System (SAP14000). Fusalage is fiberglass with built up balsa and ply construction for the wing and stabilizers.

SPECIFICATIONS:

• Wingspan: 40.5 inches
• Fuselage: 40 inches overall length.
• Flying Weight: 64.5 oz.

BUILDERS NOTE: REFER TO THE "ELECTRIC SETUP GUIDELINE" ON THE HOME PAGE TO HELP DETERMINE THE PROPER SET UP FOR FAN, ESC, MOTOR AND BATTERY.

REQUIRED ITEMS:

• 5 channel radio with mixing options
• 6-8 servos: 2x Ailerons, 2x Flaps, 1x Elevator, 1x Optional Rudder, 1x Steerable Nose Gear, 1x Optional Retract Valve(minimum 8 gram servos or 10 gram recommended servos)
• Electronic Speed Control
• BEC if using more than four servos in the jet
• Li-Po Battery
• Transmitter and Receiver
• Lithium-polymer battery charger
• 1' 12g Silicone Wire Blk
• 1' 12g Silicone Wire Red

3.5 Gilt Connector

• Deans Connector
• 2x 3" "Y" Servo Connector (one for ailerons and one for flaps)
• 5x 18" Servo extensions (ailerons, flaps, elevator)
• 12" Servo extensions (throttle)
• Also needed is the Dynamically Balanced MB-1 motor (SAP30731) or equivalent and the 70mm Fan unit.

OPTIONAL ACCESSORIES:

Retract Kit (Additional servo needed for control valve)

Jetapult (If landing gear are not going to be used)