The Hawker Hunter from RC Lander offers a durable Super EPO body that comes with flaps, metal mechanical retracts and removable wings for easy transport. The EPO foam is a hard dense foam that has a shine to the painted finish. There are no foam injection dots/marks on the exterior of the aircraft. This is not the standard foam material that the original Hawker Hunter kits came in. The Hawker Hunter has operational flaps, retracts and rudder already installed. The kit also as a removable wing kit installed for easy transport to the flying field.

SPECFICATONS:

• Wing span: 34 inches/ 866mm
• Fuselage total Length: 45.5 inches/ 1157mm
• Weight: 53 oz./ 1.5kg up
• Fan Unit: 70mm EDF
• Power: 4S 3300mAH 25C or above

Functions:

• 1)Flaps system-included (2 servos needed for operation-HS 65 recommended)
• 2)Metal Housing Retracts system-included (3 servos needed for operation- HS-65 recommended)
• 3)Ailerons- 2 servos needed for operation- HS-65 recommended
• 4)Elevator- 1 servo needed for operation- HS 65 recommended
• 5)Rudder- 1 servo needed for operation- HS 65 recommended

BUILDERS NOTE: REFER TO THE "ELECTRIC SETUP GUIDELINE" ON THE HOME PAGE TO HELP DETERMINE THE PROPER SET UP FOR FAN, ESC, MOTOR AND BATTERY.

REQUIRED ITEMS:

• SERVOS- See above for how many servos you require
• BEC
• 60 amp or higher esc
• 70mm Fan Unit: RC Lander Metal Fan or HET 70mm fan unit with 2W-20, 2W-25, 3W or 4W brushless motor
• 2x 18" Servo Extensions
• 5x 12" Servo Extensions
• 1' Red Silicone Wire
• 1' Blk Silicone Wire
• 3.5 Gilt/Bullet Connector
• Deans Connector
• 2x 3" "Y" Connector- Ailerons and Flap function

BUILDERS NOTE: It is possible to build and fly this jet without the retracts, flaps and even rudder functions. If this is done, servos, bec and weight can be eliminated. It will be neccessary to use a bec if a 6s Li-Po combo is being used to power the edf unit.