The F9F Panther from RC Lander offers a durable Super EPO body that comes with metal mechanical retracts and removable wings for easy transport. The EPO foam is a hard dense foam that has a shine to the painted finish. There are no foam injection dots/marks on the exterior of the aircraft. This is not the standard foam material that the original F9F Panthers came in. The F9F can accomodate optional flaps and rudder. Flaps will involve slight modification to the wings for installation. The rudder is already set for installation in the kit.

SPECIFICATIONS:

• Wing span: 41 inches/1050mm
• Length: 39 inches/ 1000mm
• Height: 12 inches/ 300mm
• Flying weight: 39 to 46 oz./ 1.1-1.3kg
• Removable Wing Kit Installed
• Retracts Installed

BUILDERS NOTE: REFER TO THE "ELECTRIC SETUP GUIDELINE" ON THE HOME PAGE TO HELP DETERMINE THE PROPER SET UP FOR FAN, ESC, MOTOR AND BATTERY.

ITEMS NEEDED:

• Servos: 9g x 4 servos that would operate ailerons, elevator and rudder. An additional 3 servos are needed for retract operation. Retracts are not needed if you wish to use a bungee launch system. It is possible to lock down the gear and use only one servo for nose gear steering
• Power system: 70 mm class ducted fan unit
• ESC: 60A or above
• Radio: 4 to 6 CH (Depends on functions installed)
• Battery: 11.1 to 14.8v 3s to 4s /3000mAh or above
• 4x 12" Servo Extensions (2x ailerons, elevator, rudder)
• 3" "Y" Connector for ailerons
• BEC if more than 3 servos are going to be used
• 1' Red Silicone Wire
• 1' Blk Silicone Wire
• 3.5 Gilt Connector
• Deans Battery Connector

OPTIONAL ITEMS:

• Retract landing gear system: (Included, 3 additional servos needed for rectract operation)
• Full scale flap operation: (optional, 2 servos needed) Some modifications needed to wing to set up the flaps.
• Rudder: 1x servo needed. The kit comes set up for a rudder. If a rudder is not wanted, simply take Dubro Park Flyer Hinge Tape to lock the rudder in place.
• Jetapult Bungee Launcher